This speaker was inspired by one of the speakers that my sister used to own. Basically what the speaker does its that it transmits the sound waves from the bottom of the product through rubber onto any conductive layer, for example a table or a window. This wave transfer allows for the whole layer to become a speaker and produce sound. On the top of the product there are two heat sensitive buttons to adjust sound, and on the frontal part there's another heat sensor that turns the product on and off. Finally, in the right side, there are two plugs to connect the power source and the audio input.
The main commands that I used for this model were: project curves to make the bill and and the buttons, and pipe with boolean difference to create the rubber unions between the buttons and the plastic. and between the plastic.
Rubber Disk View
Left Side View
Right Side View
Layers View
Rendered View
Ghosted View
Naked Edges View
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.