 |
| Rhino - Layers with Edge Analysis |
 |
| Keyshot - Orthographic with Dimensions and Logo |
 |
| Keyshot - Isometric with Logo |
To made this I first drew the curve of the pipes in the right side view. Next I piped and arrayed this. After that I drew and extruded a circle for the cross section pipes. This I arrayed along curve. To make the cushion I used a new command called flow along surface. Essentially I made the cushion as a flat rectangular object and made it flow over a surface which I made by extruding one of the curves from the side view. It takes a bit of experimenting to get it to work but the results are worth it. Also I made a logo which is placed on the bottom of the left most pipe. It's made up of my initials. Finally, in Keyshot, I made the pipes stainless steel and the cushion red leather. I also played around with my text in Photoshop by adding a bevel, stroke, inner glow, color overlay, gradient overlay, and finally a drop shadow.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.