3D prints
My ring design was inspired by London designer Domini Jones' "Otto Ring". My main objective was create a ring that symmetrical with strong visual weight. I was also inspired my Egyptian jewelry.
My entire ring was produced from three initial curves. I created a circle that two curves, first by creating one side then reflecting that curve. I than used "Curve Boolean" to join the two curves. I used "Offset" to great the inner curve. I used "Fillet" to curve the edges than created the lower half of the ring using "Loft". After I sealed off the ring using Patch and Cap. I flipped the ring then "BooleanUnion" ed the two pieces.
My material choice was 24K gold. I felt this would fit its modern aesthetic well and improve its visual weight. This material would also allow me to play around a bit more with the specular settings.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.